Futurecom VR - Page 88

8G093X01 R5
VR Programming Guide
August 2022 Page 88 of 144
Field Name
Range
Description
Notes
AVRA /
GPS Tone
Enable / Disable
Check box
Enables or Disables a notification
tone at MSU speaker when AVRA
or GPS causes repeater mode
to change
AVRA
Automatic
VR
Activation
(AVRA)
Enable / Disable
Check box
Enables or Disables the
Automated VR Activation (AVRA)
Option.
AVRA
Function
Activate Only
Activate /
Deactivate
Toggle
If AVRA is Enabled then this field
can be set to one of the following:
‘Activate Only’ → Once the VR is
ON it can not be switched OFF via
the AVRA trigger. It can only be
switched OFF from the MSU CH.
‘Activate / Deactivate’ → If the
AVRA trigger is de-asserted, the
VR automatically switches ON or
OFF.
‘Toggle’ → The VR is switched
OFF every second time the AVRA
trigger is asserted.
Only applicable if AVRA
is Enabled.
The ‘Activate /
Deactivate’ setting is
typically used when the
AVRA trigger is a
Portable charger.
Removing the portable
from the charger switches
the VR ON (System
Mode). Placing the
Portable back in the
charger switches the VR
OFF.
The ‘Toggle’ setting is
typically used when the
AVRA trigger is a car
door switch. Closing the
door the first time does
not deactivate the VR.
AVRA
,
Primary
/
Second
ar y
Prefere
nce
Input
AVRA
Uses VIP
on CH
Enable / Disable
Check box
This field must be set to Enabled
when the AVRA trigger is wired up
to a VIP I/P on the Mobile Radio
Control Head or DEK.
Corresponding
configuration required in
CPS