Garmin 5000 - Enabling High Resolution Satellite Imagery

16 GPSMAP 5000 Series Owner’s Manual
Using Charts
USinG
ChartS
Enabling High Resolution Satellite Imagery
You can overlay high-resolution satellite images on the land, the sea, or both portions of the
Navigation chart when using a preprogrammed BlueChart g2 Vision SD card.
To enable satellite imagery:
1. While viewing the Navigation Chart, touch Menu > Chart Setup > Appearance > Photos.
2. Touch one of the following:
Off—standard chart information is shown on the map.
Land Only—standard chart information is shown on water with photos overlaying the land.
Blend—photos overlay both the water and the land at a specied opacity. The higher you set
the percentage, the more the satellite photos cover both land and water.
NOTE: When enabled, the high resolution satellite images are only present at lower zoom levels. If
you cannot see the high resolution images in your BlueChart g2 Vision region, either zoom in further by
touching the and buttons, or set the detail level higher by touching Chart Setup > Appearance
> Detail.
Blend at 50%
Blend at 100%
Photo Overlay Off Land Only Photo Overlay
•
•
•