JF-240UV User Manual
68
Color Correction Select the desired type of color correction.
Use color correction Activates the color correction settings from the
selected ICC Profile
Use only linearization Activates the linearization settings only from the
selected ICC Profile.
No color correction The software uses a generic CMYK profile, instead of a
profile generated from actual color measurements of
output from the device. Orange and green inks will not
be used
Output profile Select a profile from the list or select Add to add an ICC profile.
Media Select the media type the output is printed on.
Resolution Select the output resolution. The setting may differ according to different
output device used.
1. High Speed Mode: 720 x 1,440 dpi,
2. Quality Mode: 720 x 1,440 dpi,
3. High Density Mode: 1,440 x 1,440 dpi.
Outputting mode settings: The higher the value is the better the quality is, but
the longer the outputting time will be.
Color Mode Select the color mode that matches the inks set in the printer.
CMYK The image prints using a combination of cyan, magenta, yellow and black
inks.
Dither Select the dithering for the output.
Dither Type is the pattern in which the individual dots that make an image are
applied to the media. Each dither type has advantages in terms of quality and RIP
speed. The default dither type is usually the best setting for your machine.
The software offers several dithering options to optimize your output. Usually,
quality and speed are a tradeoff, with KF Diffusion offering the highest quality and
the LX Diffusion or FMXPress offering the fastest processing times.
The available patterns (in descending order of quality) are:
1. SO Diffusion
2.Error Diffusion
To Next Page