GE 369

CGCOMMUNICATIONS GUIDE MEMORY MAP
369 MOTOR MANAGEMENT RELAY – COMMUNICATIONS GUIDE CG129
191
ctd.
xxxx xxx1 xxxx xxxx Log 5/13/21/25/37/45/ Start Method
xxxx xx1x xxxx xxxx Log 5/13/21/25/37/45/ Stop Method
xxxx x1xx xxxx xxxx Log 6/14/22/25/38/46/ Start Method
xxxx 1xxx xxxx xxxx Log 6/14/22/25/38/46/ Stop Method
xxx1 xxxx xxxx xxxx Log 7/15/23/25/39/47/ Start Method
xx1x xxxx xxxx xxxx Log 7/15/23/25/39/47/ Stop Method
x1xx xxxx xxxx xxxx Log 8/16/24/25/40/48/ Start Method
1xxx xxxx xxxx xxxx Log 8/16/24/25/40/48/ Stop Method
BIT VALUE
0 Log Started/Stopped From Motor Start/Stop or Run To Fill
1 Log Started/Stopped Manually
F192 Bitmask 369 DIGITAL INPUT AND OUTPUT RELAY STATUS
xxxx xxxx xxxx xxx1 Access Switch
xxxx xxxx xxxx xx1x Speed Switch
xxxx xxxx xxxx x1xx Spare Switch
xxxx xxxx xxxx 1xxx Differential Switch
xxxx xxxx xxx1 xxxx Emergency Switch
xxxx xxxx xx1x xxxx Remote Reset Switch
xxxx xxx1 xxxx xxxx Trip Relay Status
xxxx xx1x xxxx xxxx Alarm Relay Status
xxxx x1xx xxxx xxxx Aux1 Relay Status
xxxx 1xxx xxxx xxxx Aux2 Relay Status
F193 Bitmask RRTD DIGITAL INPUT AND OUTPUT RELAY STATUS
xxxx xxxx xxxx xxx1 Digital Input 3
xxxx xxxx xxxx xx1x Digital Input 4
xxxx xxxx xxxx x1xx Digital Input 6
xxxx xxxx xxxx 1xxx Digital Input 5
xxxx xxxx xxx1 xxxx Digital Input 2
xxxx xxxx xx1x xxxx Digital Input 1
xxxx xxx1 xxxx xxxx Trip Relay Status
xxxx xx1x xxxx xxxx Alarm Relay Status
xxxx x1xx xxxx xxxx Aux1 Relay Status
xxxx 1xxx xxxx xxxx Aux2 Relay Status
1. Only shown when “ENABLE 2-SPEED MOTOR PROTECTION” is set to “Yes”
Table CG–11: Memory Map Data Formats (Sheet 27 of 27)
CODE TYPE DEFINITION