CGCOMMUNICATIONS GUIDE PROFIBUS-DP COMMUNICATIONS
369 MOTOR MANAGEMENT RELAY – COMMUNICATIONS GUIDE CG5
The media for the fieldbus is a twisted pair copper cable along with 9-pin SUB-D connector,
which connects the bus to the 369 socket on the back of the relay. The 369 Motor
Management Relay has autobaud support. The baud rates and other slave specific
information needed for configuration are contained in 369_090C.gs* which is used by a
network configuration program.
The 369 Motor Management Relay as a DP slave transfers fast process data to the DP
master according to master-slave principle. The 369 Motor Management Relay is a
modular device, supporting up to 8 input modules.
During the configuration session, all modules have to be selected in order to get the entire
area of 110 words of input data. There are no output data for processing. The following
diagram shows the possible DP Master Class 2 configuration menu:
FIGURE CG–1: Slave Configuration
To Next Page
Loading...
