Cables
GFK-0356Q Chapter 10 Cables 10-55
10
Pin A1
Pin A12
Pin B1
Pin B12
Top of I/O Faceplate
Figure 10-34. Connector Orientation on I/O Faceplate
Length*
B1 A1
B12 A12
A1 B1
A12 B12
* Length is measured from backs of connector shells as shown above
IC693CBL321 3 feet (1 meter)
IC693CBL322 6 feet (2 meters)
IC693CBL323 1.5 feet (0.5 meter)
Figure 10-35. I/O Faceplate to Terminal Block Cable
Connector Depth
The following illustration shows the space required in front of the PLC when this cable is
connected to a module. The depth of the cabinet that the PLC is mounted in should allow for the
depth added by this connector.
To Next Page
Loading...
