GE 90*-30 PLC Series - Removing a Modules Terminal Board

2-6 Series 90-30 PLC Installation and Hardware Manual – August 2002 GFK-0356Q
2
Removing a Module’s Terminal Board
To remove a terminal board:
Ŷ Open the plastic terminal board cover.
Ŷ Push up on the jacking lever to release the terminal block.
JACKING
LEVER
Ŷ Grasp pull-tab and pull it towards you until contacts have separated from module
housing and bottom pivot hook has disengaged.
PULL
a43715
TAB
Figure 2-5. Removing a Module’s Terminal Board