Results from component test
The section Results from component test contains the test results. The results are pre-
sented in the form of charts showing the response over time for each of the different
sensors. An example page is shown in the following figure.
In UNICORN 7 the chromatograms are replaced by text describing the result
of the test. In both UNICORN 5 and UNICORN 7 chromatograms can be found
in the result file.
Note:
A vertical text on each chart shows the acceptance interval used and also whether the
component in question passed the test or not.
If the test for a component fails, troubleshooting should be done; see Section 8.3 Trou-
bleshooting a failed component test, on page 117.
ÄKTA ready Operating Instructions 28960345 AD 115
8 Component test
8.2 The test report
To Next Page
Loading...
