6 Flow kit installation
About this chapter
This chapter presents the different flow kits that can be used with the ÄKTA ready, and
describes how to install an ÄKTA ready flow kit. Much of the information in this chapter
is also available in the ÄKTA ready installation wizard (part of supplied software). How
to install the gradient flow section is described in Section 7.2 ÄKTA ready gradient
flow section, on page 99.
Precautions
WARNING
Before attempting to perform any of the procedures described in
this chapter, you must read and understand all contents of the
corresponding section(s) in the Section 2.1 Safety precautions, on
page 15 as listed below:
•
General precautions, on page 15
•
Flammable liquids and explosive environment, on page 17
•
Personal protection, on page 16
•
Operation, on page 19
In this chapter
This chapter contains the following sections:
See pageSection
786.1 ÄKTA ready flow kits
806.2 Unpacking the flow kit
816.3 Mounting the flow kit
ÄKTA ready Operating Instructions 28960345 AD 77
6 Flow kit installation
To Next Page
Loading...
