11.2 Starting a run
General
Starting a run is done from UNICORN, after first having checked that all inlets and outlets
are correctly assigned, and that the volumes of inlet and outlet containers are correct.
Starting
ActionStep
In the System Control module, click Run on the File menu.1
Select the method to start. Click OK.2
A Start Protocol is displayed, consisting of a number of dialog boxes. On the
Variables page, it is possible to fine-tune the method before proceeding.
Selecting the Show details checkbox will display more detailed information.
Check that the sample volume is correct.3
Click Next or Back to navigate through the dialog pages, adding the infor-
mation required as well as your own comments.
4
Click START in the Result Name dialog box. This will initiate the method run.5
ÄKTA ready Operating Instructions 28960345 AD 175
11 Run a method
11.2 Starting a run
To Next Page
Loading...
