10.2 An example of using the Method Editor
About the example
Creating a method involves creating and naming the method, and adding blocks and
instructions to it. In this section, a simple example is used to illustrate the different steps
in the procedure.
The method produced in this example is for training purposes only. It is not
intended as an example of a production method.
Note:
In this section
This section contains the following subsections:
See pageSection
15310.2.1 Creating the method and selecting a column
15410.2.2 Block 1: Opening valves
15610.2.3 Block 2: Auto-zeroing pressure sensors
15710.2.4 Block 3: Setting PID parameters
15810.2.5 Block 4: Filling the flow kit
16010.2.6 Block 5: Equilibration
16110.2.7 Block 6: Sample load
16310.2.8 Block 7: Washing unbound sample
16410.2.9 Block 8: Elution
16610.2.10 Block 9: Regeneration
16710.2.11 Saving the method
152 ÄKTA ready Operating Instructions 28960345 AD
10 Creating a method
10.2 An example of using the Method Editor
To Next Page
Loading...
