9 Column installation
About this chapter
This chapter describes how to install a column on the ÄKTA ready. Much of the information
in this chapter is available under Column Installation of the ÄKTA ready installation
wizard (part of supplied software).
The chapter also contains instructions for running an efficiency test and for column
rinsing. Both are optional procedures that can be performed in connection with installing
a new column. Note that ReadyToProcess columns are factory tested and are supplied
with a certificate stating the results from an efficiency test performed on the individual
column.
Precautions
WARNING
Before attempting to perform any of the procedures described in
this chapter, you must read and understand all contents of the
corresponding section(s) in the Section 2.1 Safety precautions, on
page 15 as listed below:
•
General precautions, on page 15
•
Operation, on page 19
122 ÄKTA ready Operating Instructions 28960345 AD
9 Column installation
To Next Page
Loading...
