Remove the pump lid
ActionStep
Locate the bolts holding the
pump lid. Use the supplied 10
mm wrench, located on the in-
side of the front cabinet door, to
rotate the right-hand bolt
counter-clockwise, and the left-
hand bolt clockwise, until both
are fully open. It will be neces-
sary to reposition the wrench.
1
Check the position of the two
pegs at the back of the lid. The
pegs indicate when the bolts are
fully open/closed.
2
Lift the pump lid and remove it
completely.
3
86 ÄKTA ready Operating Instructions 28960345 AD
6 Flow kit installation
6.3 Mounting the flow kit
To Next Page
Loading...
