10.1. Overview
This chapter describes messages that appear on the right Workstation monitor during system operation.
Messages may indicate any of the following:
• Error Messages
• Warning Messages
• Information
When the error message appears, an error code will also be displayed on the kV, mA display field on the
control panel, if the Mainframe is connected with Workstation.
10.2. Error Recovery Steps
Perform the following error recovery procedures if you encounter problems during start-up or operation:
1. Some messages can be cleared by pressing “OK” button or taking exposure, but will periodically
re-display while the condition exists.
2. If an error message occurs, power off the system. Wait for one minute, and then reboot the system. If
this fails to restore normal operation then proceed with step 3.
3. Press the power on/off button to power off the system, disconnect the power cord, and call for service.
Refer to chapter 1 for communication center telephone numbers. Do not continue using the system.
System may fail at any time. Ignoring error and warning messages may result in equipment
damage and personal injury.
10.3. Messages
Each message contains the information of error description, how user will be affected and action
suggested. For the detailed message list, please refer to Service Manual.
To Next Page
Loading...
