Page 47 of 79 [EN] English – K0571 Issue 1
User Manual Druck DPI611
Note: If there is an electrical function already selected it
will automatically be disabled. The display will show a
screen message.
Figure 2-22 Switch Test
e. Example Procedure: Measure Voltage with Internal
Voltage Source
Figure 2-23 shows CH1 set-up to measure a DC voltage
(± 30 V) or DC mV (± 2000 mV) with Internal Voltage Source
(e.g. for use with Resistive bridge).
Note: Internal Voltage is provided by connecting to the
Vo terminals on the front of the DPI611 and enabling
Voltage (10V) or Millivolts (10V) as the electrical function.
To Next Page
Loading...
