GE LOGIQ E9 User Guide

Data Backup
LOGIQ E9 – User Guide 3-29
Direction 5454884-100 English Rev. 1
EZBackup and EZMove (continued)
6. A pop-up message appears that provides you with the
media label. Label the media, then insert the media. Press
OK.
a. Ensure that you label the media with not only the
volume name indicated on the Insert Media Message,
but with the name of the LOGIQ E9 system where this
backup/move procedure was done.
b. Update the EZBackup/EZMove log with this information
the volume information and the location of the media.
c. After the backup/move has been completed, file the
media.
NOTE: You can cancel the backup/move at any time. The system
completes backing up the current media and then cancels
the operation.
NOTE: If the system locks up during the media auto format process,
shutdown the system by holding down the power button and
boot it up again. After the system is up, replace the media to
a new one and execute EZBackup or EZMove again. To
avoid data loss, do not reuse the failed media for any other
function.
NOTE: This message appears if you press Next without inserting
the backup media: “Please insert a blank media...”. Insert
the media and continue.
CAUTION
Only cancel the backup/move in case of an emergency.

GE LOGIQ E9 Specifications

General

Type	Ultrasound System
3D/4D Imaging	Yes
Transducer Ports	4 active ports
Connectivity	DICOM, USB, Ethernet
Applications	Abdominal, Vascular, Musculoskeletal, Small Parts, Urology, Pediatric, Cardiac, Obstetrics/Gynecology
Transducers	Linear, Convex, Phased Array, Volume
Doppler Modes	Color Doppler, Power Doppler, Pulsed Wave Doppler, Continuous Wave Doppler
Elastography	Yes
Advanced Features	B-Flow, Volume Navigation
Portability	Cart-based system
Display	19-inch high-resolution LCD monitor