GE PACSystems RX3i Command Line Interface Manual

1-4 PACSystems* RX3i PROFINET Controller Command Line Interface Manual – July 2011 GFK-2572
1
Viewing the Commands
To view the commands that are available in the current mode, at the Command Line prompt enter
either:
help to see the available global and non-global commands.
? to see only the non-global commands.
help global to see only the global commands
Completing a Partially-Typed Command
Enter ? or press the Tab key to automatically complete a partially-typed command or parameter.
Note: To complete “no” to “node” use ?, not Tab.
Listing the Parameters of a Command
After a command has been fully entered, type ? to list the possible parameters for that command,
and help text associated with those parameters.
Example for showing the ARP table:
device-name>
Initial display
device-name> sho?
Enter sho? to view self-completion help.
device-name> show
Enter show to see the full command
device-name> show ?
Enter show ? to view the available show parameters.
Partial results:
arp - Show ARP table
config - Show Configuration items
device-name> show arp
Enter arp to display the ARP table.
The “No” Parameter
For certain commands, entering a no parameter produces the opposite result. For example, the
command telnetd enables telnet while no telnetd disables telnet. The Command Line Interface help
shows these commands as: [no] command.

GE PACSystems RX3i Specifications

General

Brand	GE
Model	PACSystems RX3i
Category	Controller
Language	English