GFK-2572 1-1
Introduction
A computer can monitor a PROFINET Controller module and check its operation on the network by
accessing the module’s built-in Command Line Interface. If a problem occurs, the Command Line
Interface can be used to help pinpoint the cause.
The Command Line Interface operates in background mode on the PROFINET Controller. It cannot
be used during powerup diagnostics or when the module is in firmware update mode. The Command
Line Interface may not be accessible during very heavy communications load.
This chapter describes the Command Line Interface, and explains how to use it.
Chapter 2, Monitor Commands defines the commands, counters, and Log Events that can be used
to view information about the operation of the network.
Chapter 3, Modify Commands defines additional password-protected commands that can be used
to control network functions.
To Next Page
Loading...
