GE PACSystems RX3i Command Line Interface Manual

`
show ip
GFK-2572 Chapter 2 Monitor Level Commands 2-31
2
show ip
Global Command
This command displays Internet Protocol (IP) status and counters.
show ip Command Format
show ip [conn | counters | status]
Examples
Displaying all IP Details
Screen Display
device-name> show ip
01-JAN-2000 00:44:37.0000
Network Stack Version: v4/v6 Host (v4 only build) stack ver. 3.1.2.0
<<< IP Status >>>
Ip:
1846 total packets received
0 forwarded
0 incoming packets delivered
1576 incoming packets delivered
724 requests sent out
1 dropped because of missing route
Icmp:
1 ICMP message received
0 input ICMP message failed
ICMP input histogram:
destination unreachable: 1
1 ICMP messages sent
0 ICMP messaged failed
ICMP output histogram:
destination unreachable: 1
INET route table – vr: 0, table: 254
Destination Gateway Flags Use IF Metric
-------------------------------------------------------------------------
10.10.0.0 10.10.0.2 UGS 0 gei0 0
224.0.0.0 10.10.0.2 UC 2 gei0 0
-------------------------------------------------------------------------
INET sockets
Proto Recv-Q Send-Q Local Address Foreign Address State
----- ------ ------ --------------------- ---------------- ----
TCP 0 0 10.10.0.100.23 10.10.0.1.4066 ESTABLISHED
TCP 0 0 0.0.0.0.23 0.0.0.0.0 LISTEN

GE PACSystems RX3i Specifications

General

Brand	GE
Model	PACSystems RX3i
Category	Controller
Language	English