clear statLED
3-10 PACSystems* RX3i PROFINET Controller Command Line Interface Manual – July 2011 GFK-2572
clear statLED
Non-Global Command
Normally, the STAT LED is solid green at power-up and is turned off when a fault (other than a
fault logged due to restart) is logged in the Controller’s Local Log. This command returns the
module’s STATUS LED to solid green (the Local Log table is not cleared). The STATUS LED
remains ON until another fault is entered in the local log table. This command has no effect if
the module has an invalid MAC Address (in that case, the STATUS LED is red blinking).
clear statLED Command Format
clear statLED
Example
device-name= clear statLED
STAT LED turned ON
device-name=
To Next Page
Loading...
