GE PACSystems RX3i Command Line Interface Manual

1-8 PACSystems* RX3i PROFINET Controller Command Line Interface Manual – July 2011 GFK-2572
1
Command
Description
show debug exception
Global. Displays details on the most recent software exceptions.
show debug fatalInfo
Global. Display saved fatal error debug data stored non-volatile memory.
show icmp
Global. Shows both ICMP and IGMP status and counters
show ip
Global. Shows IP status and counters.
show log [details
[<entry>]]
Global. Displays the local log table. This includes displaying the counter
that indicates the number of entries that were lost due to overflow. The
local log table is displayed with additional fault details by specifying the
optional details parameter. An individual log entry in complete detail by
specifying log details followed by the log entry number. This command is
equivalent to log.
show mac
Global. Displays active and non-volatile MAC addresses for the module’s
four external and one internal Ethernet ports.
show mem
Global. Show System Memory status for various memory pools.
show network
Global. Show Network Interface status and counters.
show node [ id | info |
status | all]
Global. The show node command shows id and info data. show node all
displays id, info, AND status data.
 id parameter, displays PROFINET Device name, IP Address, subnet
mask and default gateway.
 info parameter, displays Type of Device, Device Catalog number,
Copyright notice, Primary firmware revision, Boot firmware revision,
hardware revision and FPGA revision.
 status parameter displays the restart reason code, and other module
status. In addition, it shows whether the configuration data source is
from the Programmer or if any configuration parameters have been set
via another means (Command Line Interface, DCP or default values).
show port [all | sfp |
status | fdb |
<portName>]
Global. show port displays summary-level internal and external port
information. show port all displays detailed port information.
 sfp shows specific information on either all or specific SFP devices and
in addition shows all the SFP EEPROM contents. Some devices may
support diagnostic information and if so, the command provides this
information as well.
 status shows link status (up/down), negotiated network speed/duplex
mode, switch management state (Disabled, Blocked, Forwarding,
Learning)·, switch override status and switch monitor status (monitor
port and which ports are being monitored) on each external and internal
Ethernet port
 fdb shows the filtering database for either one port or all ports.
 <portName> shows details for the specified port name. For example
show port 1 displays detailed information for port #1.

GE PACSystems RX3i Specifications

General

Brand	GE
Model	PACSystems RX3i
Category	Controller
Language	English