GE RSDetection RS-S131-200-ER0000 - Page 52

RSDetection
User’s Manual
March 2016 S131-200-UM Rev A
Page 38
g
Measurement
Measurement Description
Unit(s)
DaqAirPressure
Pressure measured on the DAQ board. Due to the
sealed nature of the enclosure this may not
accurately reflect the exterior pressure.
bar (*)
kP
psi
HighVoltage
The bias voltage applied to the HPIC
volts
HighVoltageStdDev
The bias voltage standard deviation as measured
since the last measurement.
volts
DatabaseFileSize
Current size of the SQL database file.
bytes
DatabaseRecordCount
The number of measurements stored in the
database.
Record
Count
WindSpeed
Wind speed as measured by the option metrological
sensor. Will be zero if no sensor installed.
m/s (*)
k/h
mph
WindDirection
Wind direction as measured by the optional
metrological sensor. If the sensor is not installed, a
value of zero will be recorded.
degrees
RainAccumulation
Rainfall as measured by the optional metrological
sensor. This measurement will be reset to zero after
every measurement. If the sensor is not installed, a
value of zero will be recorded.
mm (*)
Cm
inches
AirPresure
Air pressure as measured by the optional
metrological sensor. If the sensor is not installed, a
value of zero will be recorded.
bar (*)
kPa, psi,
mmHg, inHg
AirTemperatue
Air temperature as measured by the optional
metrological sensor. If the sensor is not installed, a
value of zero will be recorded.
°C (*)
°F
Humidity
Humidity as measured by the optional metrological
sensor. If the sensor is not installed, a value of zero
will be recorded.
bar (*)
kPa, psi,
mmHg, inHg
* DESIGNATES THE DEFAULT UNIT IF MORE THAN 1 UNIT CAN BE SELECTED.