RSDetection
User’s Manual
Copyright © 2016 General Electric Company. All Rights Reserved S131-200-UM Rev A
Page 37
Measurements, descriptions, and units are shown in the Table 7.
Table 7 Measurements
This is the standard deviation as a percent of
reading for the dose rate.
The measured temperature inside the shield cover
within the electrometer.
The temperature inside the electrometer can be
outside of the shield cover.
The humidity inside the shield cover within the
electrometer.
The number of charging cycles the battery has
experienced.
Number of minutes till full charge as determined by
the battery charger.
Number of minutes till the battery is empty as
determined by the battery charger.
Current voltage of the battery.
Current being supplied by the battery. Current being
supplied by the battery to power the unit is
indicated as a negative number while current going
into the battery during a charging cycle is positive.
Temperature of the battery.
Estimated capacity remaining in the battery.
FullChargeBatteryCapacity
Estimated full charge capacity of the battery.
Estimated full charge capacity as a percent of
design capacity.
The amount of time the unit has been running. If
power is cycled this number will return to zero.
Temperature measured on the DAQ board.
Humidity measured on the DAQ board.
To Next Page
Loading...
