Initial Setup 2-1
August 2008
Introduction The PT878 Program Menu enables you to program the parameters
that define an installation site. As a minimum, the transducer, pipe
and fluid data must be entered into the meter before measurements
can be taken. The programmed data can then be saved as a site file,
and the PT878 can store up to 1 MB (or 32 site files) of data.
IMPORTANT: For menu options not discussed in this abridged
manual or if you see an error or warning screen while
programming your meter, refer to your full User’s
Manual (910-219) for further instructions.
Entering the Program
Menu
To enter the Program Menu, press the [MENU] key at the lower right of
the PT878 keypad. The Menu Bar replaces the Status Bar at the top of
the screen. Press the [X] arrow key once to scroll to the Program
Menu and press [ENTER] (see Figure 2-1 below).
Note: As an aid in following the programming instructions in this
manual, refer to Appendix A, Menu Maps.
Figure 2-1: The Program Menu
Use the [
T]and [S] arrow keys to scroll through the menu options.
Then press [ENTER] to select that option.
Vel
ocity, ft/s
Signal, dB
0.00
32
Delta
-T, ns
0.10
0.0
Volume, l/s
E0: No Errors
Pipe
Lining
Path
Fluid
Energy
Analog Input
Analog Output
Digital Output
User Functions
Site Program Meter Logging Service
Transducer
Co
Correction Factors
To Next Page
Loading...
