GE Transport PT878 - The Measurement Option

August 2008
3-6 Operation
The Measurement Option The Measurement option allows you to specify which parameter is
displayed in the current window and to select the measurement units.
1. Use the arrow keys to select the Measurement option and press
[ENTER].
2. At the Change drop-down menu option, press [ENTER] again and a
window similar to Figure 3-5 below appears.
Note: The left column in the window lists the available display
parameters, and the right column list the available
measurement units for the highlighted parameter.
Figure 3-5: The Measurement Parameters Window
1. Use the [
T] and [S] arrow keys to highlight the desired
parameter for display, and press [SEL].
2. Then, use the [T] or [S] arrow keys to select the desired
measurement unit (or diagnostics parameter).
3. Press [F3] (OK) to confirm your selections and return to Operate
Mode. Your changes will be displayed on the screen. Otherwise,
you can press [F2] (Cancel) or the [ESC] key to exit the menu
without confirming your selections.
Programming
Select Measurement
Cancel
OK
Volume
Amplitude Up
Delta-T
Velocity
Fwd Totalizer
Rev Totalizer
Diagnostics
No Unit
Amplitude Down
T Up
T Down
Gain
Soundspeed
Soundspeed, f
P# Up
Delta-T
Power
Energy
Temperature