Operation 3-5
August 2008
The Limits Option (cont.) For a bar graph display, skip the following steps and proceed directly
to the final paragraph below. For a line graph display, complete the
following additional steps:
1. Scroll to the text box for the x-axis interval value and press
[ENTER] to open the box.
2. Use the numeric keys to enter the desired interval value and press
[ENTER] to confirm the value.
3. Scroll to the text box for the x-axis units and press [ENTER] to open
the box.
4. Use the numeric keys to enter the desired interval units (seconds,
minutes, hours, or days) and press
[ENTER] to confirm the choice.
5. The final three menu options permit you to configure some of the
display details:
a. If you want to use lines to connect the data points, scroll to the
Use Lines option and press
[ENTER] to select it.
b. If you want to show the average value for the displayed
parameter, scroll to the Plot Average value option and press
[ENTER] to select it.
c. If you want to show the minimum and maximum values for the
displayed parameter, scroll to the Show Minimum and
Maximum option and press
[ENTER] to select it.
Press [F3] (OK) to confirm your selections and return to Operate
Mode. When you return to Operate Mode, the screen will display any
changes you have made. Otherwise, you can press [F2] (Cancel) or the
[ESC] key to exit the Format Menu without confirming your
selections.
To Next Page
Loading...
