August 2008
2-6 Initial Setup
Entering the Pipe Lining
Parameters
To program your pipe lining. scroll to the Lining tab on the Program
Menu (see Figure 2-4 below) and press [ENTER].
Note: The Lining option is only available for clamp-on transducers.
Figure 2-4: The Lining Option Window
1. Press
[ENTER] to open the drop-down list of pipe lining materials.
2. Scroll to your material, or if your material is not listed, select
“Other.” Press [ENTER] to confirm your choice.
Note: If your pipe lining material is not listed, consult GE Sensing
for assistance.
3. If you selected pipe lining material from the list, the correct sound
speed is entered automatically. However, if you selected “Other,”
you must enter the sound speed for your material and press
[ENTER]
to confirm the value.
4. Use the numeric keys to enter lining thickness, and press [ENTER]
to confirm the value.
5. To return to Operate Mode, press [F3] (OK) to confirm your entries
or press [F2] (Cancel) to cancel your entries.
Transducer Pipe
Path
Transducer/Pipe
Cancel
OK
Lining
Material
Tar/Epoxy
Sound Speed
2000
mmThickness
m/s
0
Fluid
To Next Page
Loading...
