GE Transport PT878 - Entering the Fluid Parameters; Entering the Signal Path Parameters

August 2008
2-8 Initial Setup
Entering the Fluid
Parameters (cont.)
Entering the Signal Path
Parameters
To program your signal path parameters, scroll to the Path tab on the
Program Menu (see Figure 2-6 below) and press [ENTER].
Figure 2-6: The Path Option Window
Table 2-2: Fluid Type Selection
Energy Tracking Windows OFF Tracking Windows ON
OFF Other Water (0-260°C)
Water (0-260°C) Oil
Sea Water Other
Oil (22°C)
Crude Oil
Lube Oil (X200)
Methanol
Ethanol
LN2 (-199°C)
Freon (R-12)
ON Water/0-260°C Water/0-260°C
Water/Glycol
(with glycol %)
Water/Glycol
(with glycol %)
Other
(single soundspeed)
Other
(min./max. soundspeeds)
Transducer
Pipe Lining
Path
Transducer/Pipe
Cancel
OK
Fluid
Path Length
Axial Length
Traverses
1
Spacing
248.92
203.2
90
mm
mm
mm