Operation 3-9
August 2008
Customizing the Softkeys If you use certain menus frequently, you can program your PT878 to
access these menus directly from Operate Mode by customizing the
softkeys ([F1], [F2] and [F3]). Then, pressing the associated softkey at
any time will open the programmed menu directly. To program your
softkeys, proceed to the appropriate section.
IMPORTANT: Softkey programming is saved globally. Thus, the same
assignments apply to all site files.
Setting a Softkey from the Site Menu:
1. Press the [MENU] key at the lower right of the PT878 keypad. The
Menu Bar replaces the Status Bar at the top of the screen.
2. With the Site Menu highlighted, press [ENTER] to open the Site
Menu window (see Figure 3-6 on page 3-7).
3. Use the [T] or [S] arrow keys to move to the FKeys option and
press [ENTER]. A screen similar to Figure 3-8 below appears.
Figure 3-8: The FKeys Menu
4. Use the [T] or [S] arrow keys to select the desired FKey (for
example, F1) and press [ENTER]. The Configure FKey window (see
Figure 3-9 on the next page) opens.
Meter Logging Service
Velocity, ft/s
0.00
32
Delta-T, ns
0.10
0.0
Volume, l/s
E0: No Errors
Signal, dB
Save Now
1 View
2 Views
3 Views
4 Views
Drive Manager
Manager
Site Program
FKeys
4
F2
F3
Clear F1
Clear F2
Clear F3
F1
About
To Next Page
Loading...
