Operation 3-1
August 2008
Configuring The Display
Options
The PT878 allows you to view 1 to 4 different measurement
parameters simultaneously in either numeric or graphical format. To
configure the display, press [SEL] from the Operate Mode window and
a cursor appears next to the parameter closest to the upper left corner
(see Figure 3-1 below). Use the [SEL] key to scroll through the
displayed measurements until you reach the desired parameter. Then,
press [ENTER] to open the Display Menu for that parameter.
Proceed to the appropriate section for detailed instructions.
Figure 3-1: Display After Pressing [SEL]
2000/11/30 09:53 AM
4
Velocity, ft/s
0.00
32
Delta-T, ns
0.10
0.0
Volume, l/s
E0: No Errors
ABC.SIT
Signal, dB
Format View Measurement
To Next Page
Loading...
