August 2008
4-4 Managing Site Files
The New Option (cont.) 2. To begin entering a name for the new site, use the four arrow keys
to scroll to the desired letter or number, and press [ENTER].
3. Repeat the previous step until you have created a site name of up
to eight characters.
Note: At any time, you may press
[F1] (Delete) to remove the last
character entered.
4. When you have finished, press [F3] (OK) to accept the name, or
press [F2] (Cancel) to leave the window without creating a new site.
If you pressed [F3] above, a window similar to that in Figure 4-5
below appears.
Figure 4-5: Template Confirmation Window
You must now decide if you want to use the site that was highlighted
in the Site Manager window (see Figure 4-2 on page 4-2) as a
template for the new site:
• Press [F2] (No) if you do not want to use the selected site as a
template (you will use the current setup data instead)
• Press [F3] (Yes) if you do want to use the selected site as a template
for the new site
After you make your selection, the meter returns to Operate Mode,
and the new site name is shown in the upper left corner of the display.
A B C D E F G H
I J K L M N O P
Q R S T U V W X
Y Z 0 1 2 3 4 5
6 7 8 9
New Site
No
Yes
New Site
Use the selected site
‘DEFAULT.SIT’ as a template?
To Next Page
Loading...
