Basic scanning operations
118 Vivid S5/Vivid S6 User Manual
R2424458-100 Rev. 2
Note: Removable media used during Disk space management,
Backup, Export or "Save-As..." do not need to be formatted in
advance as the formatting process is part of these procedures
if required.
Additional networking functions
Additional networking functions contained in this tab are
described below.
Note: Before using any of these functions, verify that the
destination PC / Network has been set up with a shared folder
(remote path) with user permissions. Configuring the shared
folder for the first time will involve your GE field-service
engineer.
Save As PDF to network path
Save As PDF Network Path is used for saving Reports as
PDFs to a destination PC or network.
1. Under "Save As PDF Network Path", in the Remote Path
field, type the remote path. For example type: \\IP
ADDRESS\DIRECTORY, where directory is the name of
the shared folder in the destination PC.
2. Click Check to verify the connection.
Note: When clicking the Check button, you might momentarily
see a "failed" message that disappears if you click Check a
second time. The system will then confirm the setting.
Remote Path
1. Under "Setting for Remote Path used for Save As...", type
the remote path as follows:
\\IP ADDRESS\DIRECTORY
2. Click Check to verify the connection.
Configurable Remote Path User
It is possible to configure an additional user name and
password for all remote paths. These settings are only used if
the system fails to log on the default user and password.
• Under Configurable Remote Path User, type the desired
user name and password as configured on the destination
PC (this is the password usually assigned by the local IT
person).
To Next Page
Loading...
