Basic scanning operations
Vivid S5/Vivid S6 User Manual 119
R2424458-100 Rev. 2
Ejecting removable media
Do not eject the CD
using the button on
the CD drive.
1. Press the "Eject" button on top of the alphanumeric
keyboard, or use the shortcut
ALT+E to eject the media.
The Eject device menu is displayed (Figure 3-6).
Figure 3-6: The Eject device menu
2. Select the relevant media.
The selected media is ejected.
Removing USB devices while in standby mode: Introduce or
remove USB devices only while system is in full shut-down
mode, or while system is turned ON, using the proper Eject
command (
ALT+E). Removing USB device while system is in
Standby may cause system failure.
Media corruption as result of AC power failure: While doing
any type of CD/DVD media-writing session, such as export,
backup, disk-management, save As etc. the system may issue
different error messages in case a writing-error has been
detected.
In the special case where the AC power to the DVD drive is
interrupted in the midst of media-writing session, some error
messages may be misleading.
It is therefore required that whenever such a failure has
occurred, the user should repeat the whole session onto a new
media. It is assumed that the previous session has failed.
Recording images on DVR
DVR recording is started and stopped from the RECORD
button on the control panel. The status of the DVR is indicated
by a symbol on the Title bar (for detail about how to use DVR
recorder, refer to "DVR (Digital Video Recorder)" on page 578).
CAUTION
When ejecting a MOD, the disk is half way ejected from the MOD
station. To avoid unintentional automatic re-insertion, take out
the MOD from the MOD station.
To Next Page
Loading...
