Stress Echo
210 Vivid S5/Vivid S6 User Manual
R2424458-100 Rev. 2
Continuous capture" on page 208 (steps 1 to 11).
The continuous
capture loop is very
big, and ending the
exam may take sev-
eral minutes if stor-
ing through a slow
network or storing
to a removable me-
dia.
2. Press Store all.
The entire Continuous capture acquisition is stored. The
examination can be ended and the image assignment,
analysis and scoring can be done on a later stage.
3. Re-open the examination if necessary.
4. Press
PROTOCOL.
The Protocol screen is displayed.
5. Press on the Continuous capture thumbnail on the lower
left corner of the Protocol screen.
The Continuous capture selection screen is displayed.
6. Assign the cineloops to the views (see page 211).
7. Press Done when finished.
8. Perform Analysis and scoring (see page 213).
9. When exiting this patient a dialogue window is displayed
asking whether the remaining continuous capture images
should be deleted.
• Press Yes to delete the remaining continuous capture
images
OR
• Press No to keep the entire continuous capture
acquisition.
The normal procedure is to delete the remaining images as
they take a lot of disk space.
Restart capture from the Continuous capture selection
screen
• Press
RESTART CAPTURE.
The recording in memory is deleted and the Continuous
capture is started again.
Resume Continuous capture
• Press
CONTINUE CAPTURE.
Resumes Continuous capture recording (only if the
Continuous capture buffer is not full).
To Next Page
Loading...
