GE Vivid S5 - Page 229

Stress Echo
Vivid S5/Vivid S6 User Manual 211
R2424458-100 Rev. 2
Assigning and storing the loops
The cineloops captured in the buffer are assigned to the stress
protocol views and stored from the Continuous capture
selection screen (see Figure 5-6).
Figure 5-6: The Continuous capture selection screen
Assigning a cineloop to a view
1. Trackball to the desired loop in order to assign it to a
particular view of the stress template.
The frame of the loop is highlighted.
2. Press
SET.
A pop-up menu is displayed with the view names of the
template (see Figure 5-7).
1. Rotate CHANGE PAGE assignable to display
other pages.
2. Cycle number and total number of cycles
3. Highlighted loop
4. Red bar: pause session
5. Grey gauge: position of the highlighted loop
within the buffer area