Getting started
Vivid S5/Vivid S6 User Manual 63
R2424458-100 Rev. 2
Full shutdown
After switching off
the system, wait at
least ten seconds be-
fore turning it on
again.
1. Press (on/off button) on the top left of the control panel.
The Exit dialogue window is displayed.
Figure 2-8: The Exit dialogue window
In case of total lock-
up of the system,
hold the on/off but-
ton down a few sec-
onds to turn the
system off.
2. Select Shutdown.
The shutdown process takes a few seconds and is
completed when the control panel illumination is turned off.
Booting up from Full Shut-down mode may take about 60
seconds.
Standby mode
1. Press (on/off button) on the top left of the control panel.
The Exit dialogue window is displayed (Figure 2-8).
2. Select Standby.
The system enters Standby mode.
Booting up from Standby mode may take about 20
seconds.
Note: Whenever the system is fully shut down or put in
standby mode, the system will automatically perform "End
Exam" to save all data and images of the current patient
into the archiving system.
Turning on the system at the new location
1. Plug the AC cable into a proper power outlet.
2. Press (on/off button) (Figure 2-11).
Battery Power Mode
When the system is operating normally, if the AC power is
interrupted or the power cable is removed from the wall outlet
the screen and keyboard will turn off, but the rest of the system
To Next Page
Loading...
