Stress Echo
Vivid S5/Vivid S6 User Manual 207
R2424458-100 Rev. 2
Figure 5-5: The buffer bar in Continuous capture
Controlling the capture process
When entering a stress level with Continuous capture enabled,
the unit is automatically set in Pause mode.
1. Press STORE or 2D FREEZE to start image capture.
“Capture” is displayed in the buffer bar, the gauge starts
filling and the percentage of filled memory buffer increases
(see Figure 5-5, page 207).
2. Press
STORE or 2D FREEZE again to stop capture.
“Pause” is displayed in the buffer bar.
When 90% of the memory buffer is filled up, the text display in
the buffer bar turns red.
The unit enters Freeze mode automatically once the buffer is
full and the captured loops are displayed in the Continuous
capture selection screen (see below).
1. Scanner's state
2. Capture session
3. Pause session
4. Buffer gauge
5. Percentage of filled buffer
To Next Page
Loading...
