165
2. BATTERY REMOVAL AND INSTALLATION
HINT:
(1) The battery is not allowed to contact lubricating grease.
(2) The battery terminal is only allowed to be softly pulled out, in order to void damaging the battery.
REMOVAL
(1) Remove the negative (-) ground cable
(2) Remove the battery positive (+) cable
(3) Loosen the fixing clamp on the battery.
INSTALLATION
Install according to the inverted order of removal.
Tighten the torque
Tighten the battery cable clip to 6N.m (61kgf.cm, 4ft.lbf)
Tighten the fixing clamp to 12N.m (123kgf.cm, 8.6ft.lbf)
To Next Page
Loading...
