gefran VDI100 Series

4.1.5. Modifying Parameters/ Set Frequency Reference
Example:ModifyingParameters
▲
Frequency Reference
Press </RESET
Press
▲
Press
Press READ/ENTER
Press
READ/ENTER
Press DSP/FUN
Flashing
for 3 sec.
Press DSP/FUN
Press </RESET
Example:SetFrequencyReference
Flashing for 3 seconds
Press RUN 1x
Display Voltage Class
Display Voltage Class
Output Frequency
Output frequency
Set Frequency Reference 0.01 Hz
Set Frequency Reference completed.
Flashing for 3 seconds
Display Frequency Reference
Set Frequency Reference
Set Frequency Reference 0.1 Hz
Set Frequency Reference 0.1 Hz
Set Frequency Reference 1Hz
Set Frequency Reference 1 Hz
Set Frequency Reference + 1Hz
Set Frequency Reference +1 Hz
Press </RESET
1x
Press </RESET
1x
Press </RESET
1x
Press </RESET
1x
Press READ/ENTER
1x
Set Frequency Reference
▲
▲
▲
▲
Press 1x
Press </RESET
1x
Press 1x
Press 1x
Press 1x
Press READ/ENTER
1x
Press </RESET
1x
Display Frequency Reference
Inverter automatically
reverts back to
display the output
frequency if no
modifications are
made within 5 sec.
Note ! When upper or lower limit is reached during editing of the frequency reference, the edit value will automatically rollover from the
lower limit to the upper limit or from the upper limit to the lower limit.
VDI100 • Instruction manual 49