42 50950106/AP0313
Lift/Tilt Control
Moving the lift arm and tilting the attachment are accomplished by movement of
the right T-bar. To raise the lift arm, pull the control straight rearward; to lower
the lift arm, push the control straight forward. To tilt the attachment forward
and downward, twist the control clockwise; to tilt the attachment up and
back, twist the control counterclockwise.
Note: The speed of the lift/tilt motion is directly proportional to the amount of T-
bar movement and engine speed.
To place the lift arm into the “float” position, push the right control handle fully
forward to detent. This mode allows the lowered lift arm to follow the ground
contour while traveling over changing ground conditions. An indicator lamp in
the indicator and warning lamp display will blink when float is activated.
Never push the right control handle fully for-
ward to detent the float control with the
attachment raised, because this will cause the lift arm to lower
very rapidly.
To Next Page
Loading...
