V 12/13
OptiMove CR07 About this manual • 9
About this manual
General information
This operating manual contains all the important information you require
for the working with the OptiMove CR07 axis control unit. It will safely
guide you through the start-up process and give you references and tips
for the optimal use of your new powder coating system.
Information about the function mode of the individual system components
- booth, axis, gun control unit, powder gun or powder injector - should be
referenced to their enclosed corresponding documents.
DANGER:
Working without operating instructions
Working without operating instructions or with individual pages
from the operating instructions may result in damage to property
and personal injury if relevant safety information is not observed.
► Before working with the device, organize the required documents and
read the section "Safety regulations".
► Work should only be carried out in accordance with the instructions of
the relevant documents.
► Always work with the complete original document.
To Next Page
Loading...
Need help?
General
