Gema OptiMove CR07 - Operating Modes

V 12/13
20 • Operating and display elements, operating modes OptiMove CR07
Operating modes
The OptiMove CR07 Axis control unit provides following operating
modes:
- Manual
- Remote
- Semiautomatic
- Keyboard lock
The OptiMove CR07 Axis control unit enables the simply creation of 255
programs with the help of the necessary parameters.
"Manual" operating mode
The manual operation permits the selection and the start of the travel
programs by the operator on the panel. In addition, the operator has the
possibility to change the program number or directly modify the running
program.
In this operating mode, all display and operating functions are possible by
the operating panel, such as:
- Program numbers selection
- Input mode/display mode selection
- Preset value setting in the input mode (only in pendulum
operation)
- Start/Stop
- Error messages acknowledgement
- System parameter mode
"Remote" operating mode
In the remote operating mode, the control unit is controlled by CAN bus
or DigitalBus.
Only a limited operation is possible by the operating panel, namely:
- Input mode/display mode selection (preset values and actual
values visualization)
- Error messages acknowledgement
This is displayed on the operating panel by lighting-up of the green
Remote LED. In the remote operating mode, the start and the stop keys
are out of function.