V 12/13
12 • Function description OptiMove CR07
Field of application
The OptiMove CR07 Axis control unit is designed exclusively for
operating electrically driven axes in electrostatic powder coating
equipments. Any other use is considered non-compliant. The
manufacturer shall not be liable for damage resulting from such use; the
user bears sole responsibility for such actions.
The start-up (i.e. the start of intended operation) is forbidden until it is
determined that the control unit and the equipment are installed and
connected according to the machine guideline (2006/42/EG). EN 60204-1
(machine safety) must also be observed.
For a better understanding of the interrelationships in powder coating, it
is recommended to read completely the operating instructions of the
other components, so as to be familiar with their functions too!
To Next Page
Loading...
