V 12/13
OptiMove CR07 General safety regulations • 5
General safety regulations
This chapter sets out the fundamental safety regulations that must be
followed by the user and third parties using the OptiMove CR07.
These safety regulations must be read and understood before the
OptiMove CR07 is put into operation.
Safety symbols (pictograms)
The following warnings with their meanings can be found in the Gema
Switzerland operating instructions. The general safety precautions must
also be followed as well as the regulations in the operating instructions.
DANGER!
Danger due to electrically live or moving parts. Possible consequences:
death or serious injury
WARNING!
Improper use of the equipment could damage the machine or cause it to
malfunction. Possible consequences: minor injuries or damage to
equipment
INFORMATION!
Useful tips and other information
Proper use
1. The OptiMove CR07 is built to the latest specification and
conforms to the recognized technical safety regulations and is
designed for the normal application of powder coating.
2. Any other use is considered non-compliant. The manufacturer
shall not be liable for damage resulting from such use; the user
bears sole responsibility for such actions. Gema Switzerland
GmbH must be consulted prior to any use of the OptiMove CR07
for any purposes or substances other than those indicated in our
guidelines.
3. Observance of the operating, service and maintenance
instructions specified by the manufacturer is also part of
conformity of use. The OptiMove CR07 should only be used,
To Next Page
Loading...
Need help?
General
