Getac S400 User Manual

8-4 Troubleshooting
 Make sure that the other device is not in “Hidden” mode.
 Make sure that both devices are compatible.
Display Problems
Nothing appears on the screen.
 During operation, the screen may automatically turn off as a result of power
management. Press any key to see if the screen comes back.
 The brightness level might be too low. Increase brightness.
 The display output might be set to an external device. To switch the display
back to the LCD, press the Fn+F5 hot key or change the display through the
Display Settings Properties.
The characters on the screen are dim.
 Adjust the brightness and/or contrast.
Bad dots appear on the display at all times.
 A small number of missing, discolored, or bright dots on the screen are an intrinsic
characteristic of TFT LCD technology. It is not regarded as a LCD defect.
The external monitor displays nothing.
 Make sure that the monitor is turned on.
 Make sure that the monitor’s signal cable is properly connected.
 Switch the display to the monitor by pressing the Fn+F5 hot key or change the
display through the Display Settings Properties.
Simultaneous display/multi-display does not work.
 Make sure that you turn on the external monitor before turning on the computer.
 Press the Fn+F5 hot key to toggle through the display options or change the
Display Settings Properties in Windows.

Getac S400 Specifications

Power

ac adapter power	90W
ac adapter voltage	100-240V
ac adapter frequency	50/60Hz

Battery

battery capacity	8700mAh
battery type	9 cells Li-Ion

Temperature

operating temperature range	0°C to 60°C
storage temperature range	-40°C to 71°C
humidity	95% RH, non-condensing

System Memory

default memory	4GB DDR3
maximum memory	8GB
memory type	DDR3

Display

display size	14 inches
display resolution	1366 x 768
optional display brightness	800 NITs

Ports & Interfaces

usb 3.0 ports	3
usb 2.0/eSATA combo port	1
serial port	RS-232 x 1

Weight and Dimensions

dimensions	348 x 258 x 49.2 mm
weight	2.9 kg