GFA TS981 - Connecting External Devices

12
L1
L2
L3
PE
L1
L2
L3
PE
L
PE
N
L
PE
N
SI 25.15 WS,
=
SI 45.7 WS
3
-
phase with neutral
3~, N, PE
220–400 V / 50-60 Hz
3
-
phase without neutral
3~, PE
220–400 V / 50-60 Hz
1
-
phase symmetrical
1~, N, PE, sym.
220– 230V / 50-60 Hz
1
-
phase asymmetrical
1~, N, PE, asymmetrical
220–230 V / 50-60 Hz
NOTICE
Damage due to moisture or penetrating foreign bodies
 Check that all cable glands are tight.
 Seal open and unused cable entries with blanking plugs. This will prevent moisture or foreign bodies such
as insects from penetrating.
7 Connecting external devices
WARNING
Danger to life from electric shock!
Improper wiring may result in severe or fatal injury from electrical current.
 Allow only qualified electricians to carry out the work.
 Disconnect all cables from the power supply.
 Secure the mains disconnector against plugging in or switching it on again.
 Observe valid regulations and standards.
 Use suitable tools.

Check the insulation of cables and make sure that cables outdoors ar
e protected.
i
NOTE
The inputs of the following safety devices of the control are rated Performance Level c (PLc):
 Slack-rope switch
 Pass-door switch
 Safety edge
 Limit switch system
 Safety circuit of the drive unit

Emergency STOP control device
i
NOTE
Connect only sensors that comply with the current EN
12453 and are suitable for
Performance Level c.