GFA TS981 - P 9.2 - Readout of Fault Indications; P 9.3 - Readout of the Cycle Counter Since Last Programming Change; P 9.4 - Readout Software Version

43
P 9.2 - Readout of fault indications
With this menu item, you can read out the last 6 fault indications of the door control. After selecting the menu
item, the display changes and shows the last six fault indications. First an F is shown, then the number of the
fault indication. The first fault indication displayed is the most recent.
9.2
Readout of fault indications
The display changes and shows the last 6 fault indications.
i
NOTE
An error that occurs several times in a row is only saved once as long as no other error has occurred in the
meantime.
P 9.3 - Readout of the cycle counter since last programming change
This menu item shows the number of cycles the door has run since the last programming change. The counter
increases by 1 every time the door reaches the final limit position OPEN.
9.3
Readout of the cycle counter since last programming change
After selecting the menu item, the display ch
anges 7 times to show a 7
-
digit
number. The left side of
the two-digit display shows a symbol for the current position of cycle counter. The right side shows
the number of the current position. The example below shows 950.000 cycles.
0
9
5
0
0
0
0
.
.
►
.1
Cycle counter of the last change in programming
.2
Number of activations of slack-rope, pass-door and crash switch
P 9.4 - Readout software version
This menu item displays the software version of the door control. For drive units with GfA frequency inverter,
the software version of the motor is shown as well.
9.4
Readout software version
The display changes and shows the number of the software version.