GFA TS981 - P 2.5 - Limiting Reversals

32
P 2.5 - Limiting reversals
Activate this menu item only if automatic closing 2.3 is enabled. When automatic closing is enabled, the door
moves to final limit position CLOSED after the set time. The door reverses when hitting an obstacle during
movement. This means that the door changes the direction of movement and moves to the final limit position
OPEN. Thanks to automatic closing, the door tries to close again after the set time has elapsed. This will
continue until the obstacle is removed.
To prevent continuous opening and closing in this situation, you can specify a maximum number of successive
reversals. When the specified number has been reached, the door stops in final limit position OPEN.
i
NOTE
When the door exceeds the
set number of reversals, fault
indication
F 2.2
appears.
2.5
Limiting reversals
.0
Deactivated
.1 – 1.0
Adjustable from 1 to 10.
.1 = 1 reversal
1.0 = 10 reversals

Factory setting
:
.2