GFA TS981 - P 7.2 - OPEN Relaying; P 7.5 - Status Reporting Function; P 8.5 - Setting the Maintenance Cycle Counter

41
P 7.2 - OPEN relaying
The interlock can be operated without command devices inside the interlock. A time can be set after which the
other door opens automatically after the first door has closed completely.
7.2
OPEN relaying
.0 -
1.0
.0
= Relaying on OPEN command is deactivated
.1 - 1.0 = Relaying on OPEN command is activated Command delay after closing the first door
optionally 1 to 10 seconds.
P 7.5 - Status reporting function
You can only use this menu item when a status reporting module is connected to the SMF interface.
7.5
Status reporting function

.0
Off.
.1
Status reporting function for the GfA reporting module
.2
Status reporting function for interface module with unidirectional RS 232.
P 8.5 - Setting the maintenance cycle counter
With these menu items, you set a reminder for the maintenance of the door. The maintenance cycle can be
set between 1,000 and 99,000 cycles. The counter decreases by 1 every time the door reaches the final limit
position OPEN. When the counter reaches the value 0, the setting from menu item 8.6 is activated.
8.5
Setting the maintenance cycle counter

.
0
Deactivated.
.1 – 9.9
Activated.
Counting down from
.1
= 1,000 cycles to
9.9
= 99.000 cycles.