GFA TS981 - Safety and Operation; Explanation of Symbols; Intended Use and Target Audience

4
1 Safety-relevant chapter
Explanation of symbols
The following symbols are used in these installation instructions:
DANGER
Safety note:
Non
-
compliance will result in death or severe injury.
WARNING
Safety note:
Non
-
compliance can result in death or severe injury.
CAUTION
Safety note:
Non
-
compliance can result in injury.
NOTICE
Note:
Non
-
compliance can result in material damage and impairment of product functionality.
i
NOTE
Note:
Points out useful additional information.
Intended use
The door control is intended for installation in a force-actuated door with GfA limit switch system.
The drive unit must be protected against moisture and aggressive environmental conditions (such as corrosive
substances). The drive units are only suitable for indoor use. Appropriate protective measures must be taken
for outdoor installation. The drive unit is not intended for hazardous areas. The values specified in the
technical data of the drive unit must not be exceeded. The safe operation can only be ensured if used as
specified.
Target audience of these installation instructions
As a user or operator, contact the manufacturer for your door system. These installation instructions are
geared towards qualified persons trained in the handling of door systems. Expert knowledge, relevant skills
and practical experience are what set apart qualified persons. They are capable of safely carrying out the tasks
involving installation, maintenance and modernisation according to the instructions.
A trained electrician must carry out the electrical installation. Trained electricians meet the following
requirements:
 They are familiar with the applicable safety and accident prevention regulations.
 They recognize hazards relating to electricity and the door control and take safety precautions.